Tired of your wrenches rusting out and stripping?
Me too! So I had some made and ordered extra for you
T30 and T40 Titanium wrench set
Only 15 sets!
Venmo $40 USD to @patrick-kanzler-1
Shipping to US (only) included
9 Likes
thank you!
10 remaining!
Heroic..
.
Any idea what the risk of bending/breakage is here? I know titanium hand tools can be notoriously fussy especially when machined into something like a torx bit. I am pretty interested in a set though, looking at my currently rusted tool.
Sorry, I dont know the answer to that. I’m not really a tool maker, just a foiler sick of rusting gear
I ordered a set to keep in my wet bag. When will you ship out the tool sets?
Nice! Ordering one now.
I’ll volunteer to design a 3D printed plastic holder for these for the pocket of my life vest on downwind runs. I hate having them clank around and I also lost a couple L wrenches over the years just letting them pop out by mistake. personally, I’m only going to use these on runs where they will get salty wet, and generally use my good stainless tools our of the back of the van. I do think the titanium will be a little less durable but fine for occasional use at the end of a run
2 Likes
For what it’s worth, I’ve used the foil lite titanium tools for a year or so with no issue. Definitely limited in the amount of torque you can put on them, but…I generally just make sure to use the same tools to loosen as you did to tighten.
1 Like
I’m going to ship every Friday until they are gone. 7 remaining as of this writing.
7 Remaining sets as of this writing.
I’m shipping out first round today and will ship again next Friday.
I’ll take a set too.
Did you send a payment? I dont think I got one from you
4 sets remaining.
got em, and they are really nice, thank you
Received. So legit, thanks!!!
Sorry, no. I didn’t understand the instructions. What’s the best way?
NM, got it. Venmo coming
I received my toolset. The T30 works well.
However the T40 doesn’t fit deep enough into a M8 torx head. It doesn’t seem to have the same taper as my Axis T40 tool. Anybody else having the same problem?